How to inflate and deflate aluminum foil balloons
Balloons are very common, and aluminum foil balloons are one of the most common ones. It is well known that aluminum foil balloons can be repeatedly inflated and deflated and reused, so if you want to know how to inflate aluminum foil balloons, we have prepared for you.
How to inflate aluminum foil balloons?
Before inflating an aluminum foil balloon, you must first find the inflation nozzle. The inflation nozzle of each aluminum foil balloon has an indicator color. Peel off the outer skin of the indicator color and put it into the inflation nozzle of the pump.
During the inflation process, always pay attention to the inflation state of the aluminum foil balloon. Do not over-inflate the aluminum foil balloon, otherwise it may explode.
What should I know before inflating?
1. Aluminum foil balloons are automatically sealed, and pressing the air nozzle can seal it.
2. Inflate aluminum foil balloons slowly. If there is any sticky ball skin, it must be carefully separated before inflating. Otherwise, it is easy to inflate the balloon membrane. If you encounter a shape composed of two parts, you can inflate the bottom first, and then slowly push the air to the top.
3. When inflating, hold the balloon with your hands at any time, and stop inflating when it becomes hard. Aluminum foil balloons are not elastic, and over-inflation will cause them to rupture.
4. Avoid contact between balloons and sharp objects, rough surfaces, excessive squeezing, and exposure to sunlight.
5. Since gas expands and contracts with heat, when the temperature difference changes greatly, pay attention to replenishing or deflation, especially when entering a higher temperature environment from a lower temperature environment, be sure to fully deflate.
How to deflate an aluminum foil balloon?
Find a balloon support rod, that is, a hollow rod, which should be longer, about 30cm, and insert it along the air hole. Press the balloon carefully and the air will come out.
Making balloon road signs
Balloon road signs are very common in wedding/birthday/party decorations. They are beautiful and have a great atmosphere. In fact, making balloon road signs is very simple. Here is how to make balloon road signs:
Before making them, you must first understand the composition of balloon road signs: a water-filled base + a pole + balloons
The production steps are as follows:
1. First prepare the required balloons, inflate each balloon, and tie every two balloons together.
2. Fill the base with water, connect the vertical pole, and insert it into the base.
3. Wrap two groups of balloons together on the vertical pole and make them into the desired shape
4. 18-inch or 24-inch large balloons can be fixed with a long balloon or rubber band or glue dots.
5. Finally, add balloon decorations (fixed with glue dots), KT version or bows, etc.
Beautiful Bow Bobo Balloon
Oversized floating Bobo balloons are very popular recently. How to make them?
First, you need to prepare 18-inch latex balloons, 24-inch Bobo balloons, and balloon ribbons
1. Make the balloon into a set of balls. You can use a wooden stick or a straw. First, put the latex balloon in it, and then put the Bobo balloon outside the latex balloon
2. Inflate the balloon. It should be noted that you only need to inflate the inner balloon
3. Make a beautiful bow with a ribbon
4. Use glue dots to stick the bow on the balloon at will.